Use este identificador para citar ou linkar para este item: http://repositorio.ufla.br/jspui/handle/1/11250
Título: Electrochemical feasibility study of methyl parathion determination on graphite-modified basal plane pyrolytic graphite electrode
Palavras-chave: Methyl parathion
Basal plane pyrolytic graphite electrode
Square-wave voltammetry
Graphite
Drinking water
Data do documento: 13-Jun-2016
Editor: Sociedade Brasileira de Química
Citação: OKUMURA, L. L. et al. Electrochemical feasibility study of methyl parathion determination on graphite-modified basal plane pyrolytic graphite electrode. Journal of the Brazilian Chemical Society, São Paulo, v. 22, n. 4, 2011.
Resumo: A low-cost electrochemical method was developed for the determination of trace-level of methyl parathion (MP) based on the properties of graphite-modified basal plane pyrolytic graphite electrode (graphite-bppg). A combination of graphite-bppg with square-wave voltammetric (SWV) analysis resulted in an original, sensitive and selective electrochemical method for determination of MP pesticide in drinking water. The electrode was constructed and the electrochemical behavior of MP was studied. Immobilization is achieved via film modification from dispersing graphite powder in deionized water and through pipeting a small volume onto the electrode surface allowing the solvent to volatilize. The strong affinity of the graphite modifier for the phosphorous group of the MP allowed the deposition of a significant amount of MP in less than 60 seconds. The cyclic voltammetric results indicate that the graphite-bppg electrode can enhance sensitivity in current intensity towards the quasi-reversible redox peaks of the products of the cathodic reduction of the nitro group at negative potential (peak I = 0.077 V and peak II = –0.062 V) and that the cathodic irreversible peak (peak III = –0.586 V) in comparison with bare bppg electrode and is also adsorption controlled process. Under optimized conditions, the concentration range and detection limit for MP pesticide are respectively 79.0 to 263.3 mmol L-1 and 3.00 mmol L-1. The proposed method was successfully applied to MP determination in drinking water and the performance of this electrochemical sensor has been evaluated in terms of analytical figures of merit.
URI: http://repositorio.ufla.br/jspui/handle/1/11250
Aparece nas coleções:DQI - Artigos publicados em periódicos



Este item está licenciada sob uma Licença Creative Commons Creative Commons